How to Install HID Lamp On Motorcycles In order for Safe and Sustainable

HID lights have a beam of light that is brighter than standard bulbs. Therefore, many of which're a fan and apply it on a motorcycle. Thus the night journey has become increasingly apparent, however much the modifiers are paying less attention to the installation of these HID lamps. Al outcome lights be durable and worse still damaging other components. Primarily again the injection motor, to do some checking beforehand as the condition of the battery.

HID motorcycle

How to install HID lamps on a motor injection is done by converting electric current into DC or direct current. The way is to remove the yellow wire on kiprok. As for the yet to be made DC injection well (full-wave) so that the battery does not easily come up short. It can be applied kiprok Honda's Tiger. In addition, note the condition of your motorcycle battery. Premise is that if the voltage is less than 12 volts good idea to replace it with a new one. If it will not impact on the other electrical systems are so less than the maximum. If your bike has AHO or automatic Headlamp On the good is also mounted on / off switch.

Installation of HID lamps should pay attention to the daily ballast specifications. and lamps. Use ballast least 35 watts and a maximum of 55 watts. If the size is too large ballast will lead to rapid melting reflector. As for the size of the lights use between 4300 K to 6000 K. The radiation maximum of HID lights is quite hot, so air holes in the reflector have to function optimally. Need not be removed because it will make dirt easily entered. You can use a small foam in the hole so that the dirt does not enter ,. Lastly, when you turn on the motor do not immediately turn on the lights give pause of approximately 3 minutes. This is so that the voltage at the battery under normal circumstances. Similarly when turning off the motor, turn off the lights first and turn off the engine. This is often overlooked by the rider so easily damaged ballast.

Well that was How to Install HID Lamp On the Motor so durable and safe or not damage other components. So kesimpulanya there are five points that must be considered when installing the HID lamps installed on / off switch for the motor AHO, battery voltage can not be less 12v, consider the specifications of ballast and lamps, reflectors put foam on the hole, and turn on the lights when the battery is in a normal state